Filter
Top Products
Chapter 3
3.5.2.2.1.4 2.2.1.4 Standard/Spectral Sense
To view the status of these parameters, press the T (Down) key. The following
screen is displayed:
STATUS |STANDARD ---
2.2.1.4 |SPECTRAL SENSE ---
3.5.2.2.1.5 2.2.1.5 Pilot Symbols/Frame Size
To view the status of these parameters, press the T (Down) key. The following
screen is displayed:
STATUS |PILOT SYMBOLS ---
2.2.1.5 |FRAME SIZE ---
Press the W (Back) key to return to the S2 Status menu.
3.5.2.2.2 2.2.2 Source 1 Configure
This menu allows access to and configuration of various Source 1 Input 1
parameters. To access this function, press the T (Down) key. The following screen
is displayed:
SOURCE 1 |CONFIGURE Input 1 (L-band)
2.2.2 |(UNLOCKED) >
3.5.2.2.2.1 2.2.2.1 LNB LO Frequency
To view and edit the current settings of the Source 1 Low Noise Block (LNB) Local
Oscillator (LO) Frequency, press the X (Forward) key. The following screen is
displayed and the Edit key is lit:
SOURCE 1 |LNB LO FREQUENCY
2.2.2.1 |00000.000 MHz (UNLOCKED)
To edit the LNB LO frequency setting:
1. Press the Edit key. The cursor appears below the first number.
2. Edit the parameter value as required using the W (Back) and X (Forward) keys
to select each digit in turn, and then using the S (Up) and T (Down) keys to
increment or decrement the digit.
3. Press Save to save the new settings or Edit to abandon the operation and
return to the current setting.
3.5.2.2.2.2 2.2.2.2 Satellite Frequency
To view and edit the current settings of the Source 1 Satellite Frequency, press the
T (Down) key. The following screen is displayed and the Edit key is lit:
EN/LZT 790 0005 R1A
3-18