Filter
Top Products
Chapter 5
• Custom Src IP - allows input of the Custom source IP.
User-editable fields in the Common section:
• Link Speed – allows the selection of the IP output card link configuration.
• Spanning Tree – checking this box enables the spanning tree protocol.
User-editable fields in the IP Output Status section:
• Swap RIP (Routing Information Protocol) Metrics - checking this box enables
this function.
User-editable fields in the MGP Parameters section:
• MSM IP - allows input of the MSM IP address.
• TX Interval - allows input of the Tx interval in seconds. A value of 0 means MGP
is disabled.
User-editable fields in the RIPv2 section:
• Timeout - allows input of the timeout in seconds. A value of 0 means RIP
updates are disabled.
• Resume on Reboot - checking this box enables RIP + TS resume on reboot.
Any changes which are made to the Output page may be confirmed by selecting the
Apply Changes button. Selecting the Refresh button will ensure that the latest
information is being displayed from the current values of the equipment.
5.2.13 Download
This page gives access to the over-air-download status of the receiver, if a
download is in progress. A percentage (%) complete of download is displayed. To
view this screen, select the Download tab from the current web page.
Figure 5.34 Download Web Page
There are no fields on this page which can be edited by the user. To ensure that the
most recent information is displayed, select the Refresh button.
Note: The unit should not be power cycled (turned off and on) during download.
EN/LZT 790 0005 R1A
5-37