Open as PDF
Barco DPMS Screen Saver
68 MGP D5 Dicom Theater Lite
On Barco CORONIS displays, the I-GUARD will stabilize the image
within a few seconds after the display returns to the active state
so there is no need for a warm-up time period.
Use As Logon Screen Saver
Check the box to use the Barco DPMS Screen Saver when no one
is logged into the system.
Uncheck the box to use the default screen saver when no one is
logged into the system.
Getting started with the Barco DPMS Screen Saver
The easiest way to get started is to select an existing settings
scheme and then modify it with your preferences. Settings
schemes are separated into two kinds, DEFAULT (global) and
Upon installation, three default settings schemes are installed
and no private settings schemes are installed.
Default settings schemes are visible to all users of the system.
However, they can be modified only by users with administrator
privileges. If a user who does not have administrator privileges
tries to save a scheme using an existing default scheme name,
an error message is displayed saying “you must have
administrator rights to modify a default scheme.” If an
administrator saves a scheme using an existing default scheme
name, a message is displayed to tell the user that the
modification is saved to a default scheme and will be visible to
all users. If the administrator saves a scheme using a new name,
then the user is asked if the scheme should be saved as a default
scheme or a private scheme. Since there is no distinction
between how a default scheme and a private scheme is
displayed, it is highly recommended that the user uses a
different naming convention to distinguish the two (i.e. use
“DEFAULT: ...” for default schemes).
Private schemes are personal. They are not shared and are visible
only to the users who created them. All users of a system,