Filter
Top Products
Display controller installation
34 MGP D5 Dicom Theater Lite
6. Connect the primary display to the connector marked “VID 1”
on the BarcoMed 2MP2CP display controller using the
provided DVI cable (see figure 8). For a dual-headed
BarcoMed 2MP2CP setup, connect the secondary display to
the other connector on the display controller.
7. Reconnect the power cord, turn on the power, and boot the
system as usual.
Running multiple BarcoMed 2MP2CP Display Controllers in a single host
The physical order of the displays may vary when you are
running multiple BarcoMed 2MP2CP display controllers. This is
due to the PC’s PCI bus control in the system BIOS, and not the
BarcoMed display controller. It may become necessary,
depending on how your PC’s BIOS configures the PCI bus, to
switch your DVI display connections to achieve a linear desktop
configuration.
Figure 8