Filter
Top Products
Map Reference
The Map Reference selection allows you to choose
either the Destination Waypoint (Dest) or your
current position with an airplane icon (Plane) as the
center point of the Moving Map display.
1. In the Map function, turn the
LARGE knob to reach
the Map Setup page. Press
SEL. The value will
flash. Turn the
LARGE knob to choose Map Ref for
selection. Or, press the Map Reference (REF) smart
key to toggle through the choices.
Route Line:On
Map Orient:North
Map Ref:Plane
·
2. Turn the
SMALL knob to choose Dest or Plane.
Press
ENTER after completing your choices. It is not
necessary to press
ENTER if you used the smart key.
Identifier and Waypoint Type Selection
The Identifier & Waypoint Type page allows you to
choose the type of waypoint identifiers that will be
displayed on the moving map. You may control the
look of your map screen for each type of waypoint by
choosing to show the symbol and Identifier, symbol
only, or to turn that type of waypoint “Off.” The
symbol for each waypoint type is shown in each
selection. When “Off” is selected, no symbol or
identifier will be displayed for that waypoint type.
You may use the “smart” keys to toggle through the
selections. The “smart” keys always allow you to
select their waypoint type while viewing the MAP
display. Note that an airport with a runway of 0
length will not appear on either the nearest list, or on
the map if a length is set for the runway limit. See
page 12 for details on Runway Limits.
4-6
Moving Map Functions
ENTER
SEL
REF