Apollo 55 Stereo Amplifier User Manual


 
approach. You will now return to Approach
Transition mode. The Approach Active light will
go out and the CDI will gradually go back to
Approach Transition CDI sensitivity (from 0.3 nm
to 1.0 nm full-scale).
As soon as you enable sequencing, the Apollo GX will
sequence to the next waypoint in the flight plan. This
is the next waypoint in the published missed approach
procedure.
If the next waypoint is the MAHP, it is an automatic
holding point and sequencing will again be
automatically suspended. The OBS/HOLD light will
come back on. Operation will change from Approach
Active to Approach Transition.
3. Verify or select the next waypoint in your flight
plan. If the active waypoint is not the one you wish
to navigate to, select a new active waypoint. If the
active waypoint you want is already in your active
flight plan, the easiest way to select it is to press
FPL, to enter flight plan mode. Turn the SMALL
knob until the waypoint you want is shown as the
“TO” side of a flight plan leg . Then press
DIRECT-TO and ENTER to select the waypoint.
Note
If the same waypoint appears in the
approach sequence more than once, be sure
to turn to the occurrence you wish to select.
4. If a specific inbound course to the active waypoint
is to be intercepted or flown, press
DIRECT-TO
twice.
5. Set the desired inbound course with the
LARGE and
SMALL knobs. If flying a holding pattern, press
OBS/HLD. Then, press ENTER. Selecting an
inbound course in this manner will suspend flight
plan sequencing and the
OBS/HLD annunciator will
light. See page 24 for details on holding patterns.
9-14
Approach Basics (GX50/60)
FPL
D
ENTER
D D
ENTER