Filter
Top Products
Start Up Displays
The Start Up Sequence runs each time the unit is
powered on. The Start Up Sequence varies between
units due to installation differences. The initial start
up message is displayed for about three seconds.
Apollo GX
By II Morrow
Startup Bypass During the startup sequence, press the SKIP “smart”
key to stop the initial testing. You will be able to use
all functions.
Quick Comm
(GX60/65
Only)
Press the COM key during the startup sequence to
enable immediate use of the Comm function in the
GX60/65.
Comm Radio
Test
(GX60/65)
In the GX60/65, if the Comm software fails, the
following message will be displayed. You must then
have the unit serviced before you can use it.
COM radio
FAILURE !
Service Now
If your Apollo GX suffers both EEPROM and RAM
failure, you must reset the unit type. Select the unit
type with the
SMALL knob and then press ENTER.
This will allow you the ability to still use the Comm
and Approach functions.
Memory Failure
Select Unit type
GX60
Start Up Displays
11-1
SKIP
COM