Filter
Top Products
OBS DTK: 151° to
ROARK iaf man
brg 356 dtk 356
6. If you do not wish to hold or execute a procedure
turn at the next waypoint, press
OBS/HLD to enable
sequencing at the active waypoint. You may also
want to manually select a flight plan leg to
intercept. In this case, press
FPL, turn the SMALL
knob to the desired leg and press ENTER. Press
ENTER again to activate it.
7. After you have executed the missed approach, you
may want to proceed to another destination or you
may want to execute the same approach or another
approach to the same airport.
Canceling An
Approach
Whenever the Approach Active annunciator is lit, an
approach may be terminated by a single action of the
pilot. You may want to cancel an active approach to
try the approach again, choose another approach, to
proceed to another airport, or in response to an “Abort
Approach” message. In any case, you must follow the
appropriate missed approach instructions.
1. Press the
OBS/HLD key to cancel the approach.
Canceling an approach does the following:
·
Sequencing is enabled
·
The unit returns to Approach Transition
operations
·
Approach Active annunciator turns off
·
Approach annunciator remains turned on
·
CDI scales to 1 nm full-scale deflection
·
RAIM alarm limit goes from 0.3 nm to 1.0 nm
Though you have canceled the active approach, it is
still loaded and enabled. You may activate a previous
9-15
Approach Basics (GX50/60)
OBS/HLD
WPT SEQ
ENTER
ENTER
FPL
OBS/HLD
WPT SEQ