Filter
Top Products
80 TASCAM LR-10
13–Using the tuner
This unit has a built-in tuner. By inputting the sound of an
instrument, you can use the tuning meter on the display to
tune that instrument accurately. In addition, you can output a
tone for tuning from the built-in speaker or the /LINE OUT
jack, which is convenient for tuning multiple instruments
simultaneously, for example.
Preparation
1. Press the TUNER button to open the TUNER screen.
2. The
MODE
item is shown. Use the [ª] button and
Á button to select the tuner mode. The options are
AUTO ( [ª] : chromatic tuner mode) and OSC. (Á :
oscillator mode).
After selecting the mode, press the TUNER button again to
make settings for that mode.
3. The first item shown for each mode is
CALIB
. Use this to
set the frequency of A between 435 Hz and 445 Hz.
The setting value is shown on the right side of the screen.
This setting is the same for both tuner modes.
Use of each tuner mode is explained below.
NOTE
The signal input through the left MIC/LINE input channel is
used for tuning. When using the built-in microphones to tune
acoustic guitars and other instruments that have rapid sound
decay, in particular, tune the instrument as close to the left
built-in microphone as possible.