Filter
Top Products
TASCAM LR-10 49
The factory default setting is
MID
.
Change it to
HIGH
if the input level is too low and to
LOW
if
the input level is too high.
TYPE:
Set the built-in microphones to
STEREO
or
MONO
. The
factory setting is
STEREO
.
If you select
MONO
, the left and right channels are
combined into the same signal.
LOW CUT:
The factory default setting of the low cut filter is
OFF
, but
you can also select
40Hz
,
80Hz
or
120Hz
as the cut-off
frequency for a low cut filter.
LEVEL CTRL:
Use this to set the level control function.
Set it to
AUTO
to have the LR-10 automatically adjust the
input gain according to the input level. Loud sounds and
quiet sounds are both adjusted to the same level.
Set it to
LMT
to have the LR-10 automatically limit the
input gain so that input level of loud sounds is reduced to
prevent distortion.
The factory default setting is
OFF
.
3 Press the HOME button to return to the Home Screen.
NOTE
Try using one of the low cut filter settings when recording
•
outdoors or another place where the unwanted sound of
wind is being recorded.
When recording live performances and in other situa-
•
tions where unexpected loud sounds might occur, set
this function to
LMT
to prevent input clipping and allow
recording without distortion.
Use the LR-10’s built-in effects as necessary on the input
•
source signal. (See “Using the built-in effects” on page 78.)
Adjusting the input level
You can adjust the level of the mic/line input.
Use the INPUT volume control on the right side panel to
adjust the input level of the built-in microphones or the LINE
IN jack.
5–Recording