Filter
Top Products
72 TASCAM LR-10
10–
Loop Playback/Repeat Playback/Single Track Playback
In ordinary playback mode, unless you do something to stop
it, once playback starts, it will stop only when the end of the
last le in the current playback area is reached. By making
the settings and conducting the operations described in this
chapter, however, you can also make the unit loop a section
of a le that you choose, repeat all the les in the current
playback area, play a single track repeatedly or play a single
track once and stop.
NOTE
Accurate assignment of IN (starting) and OUT (ending) points
is not always possible for variable bit rate (VBR) MP3 les.
Using loop playback (standard
mode)
Use this function to continuously repeat playback (loop) part
of a le that you select.
1. During playback (or when paused), press the LOOP
button to set the point where you want to start loop
playback.
The current position is set as the IN (starting) point.
2. Press the LOOP button at the point when you want loop
playback to stop.
The current position is set as the OUT (ending) point, and
loop playback between the IN (starting) and OUT (ending)
points begins.
The current positions of the IN (starting) and OUT (ending)
•
points are shown by the
and
icons that appear below
the playback position display bar on the Home Screen.
During loop playback the icon also appears.
To stop loop playback, press the
•
LOOP button. This also
clears the loop interval setting.
3. Press and hold the LOOP button to open the
LOOP
SET
pop-up.
4. Use the Á, Ô, and [ª] buttons to move the
IN (starting) point to the desired position. Press the
 button to save the IN (starting) point.