Filter
Top Products
50 TASCAM LR-10
The PEAK indicator to the right of the display lights red
just before the recording level begins to distort. Play the
instrument or start playback on the connected device, and
input the loudest volume you intend to record. Set the INPUT
level as high as possible without making the PEAK indicator
light red, and set the INPUT level as high as possible without
making the PEAK indicator light red.
CAUTION
In order to hear through headphones the sound that you are
recording from the built-in microphones or the line in jack,
the mic/line input must be ON ( or ). If the input is
o ( or ), press the ¶/MIC button to turn it ON (
or ).
The input can be turned ON/OFF during recording.
Recording
Before following these procedures, adjust the input level and
open the Home Screen.
1. Press the RECORD [º] button briefly to start ordinary
recording.
When recording starts, the RECORD [º] button indicator
lights and the display shows the elapsed and remaining
recording times.
Press and hold the RECORD [º] button to enable the
pre-record function and put the unit into recording
standby. The RECORD [º] button indicator blinks when in
recording standby. (See “Recording a few seconds before
pushing the record button (pre-recording)” on page 51.)
2. Press the [ª] button to stop recording.
To pause recording, press the RECORD [º] button. To
resume recording to the same file, press the RECORD [º]
button again.
Press the [ª] button after pausing to complete the
creation of an audio file with the music recorded up to the
moment that recording was paused.
5–Recording