Filter
Top Products
TASCAM LR-10 51
Recording a few seconds before
pushing the record button (pre-
recording)
The unit can capture up to 2 seconds of input signal during
recording standby, allowing recording to start before the
RECORD [º] button is pushed.
1. Press and hold the RECORD [º] button briefly to start
recording standby. The RECORD [º] button indicator
blinks, and the PRE ( ) icon appears on the display.
2. Press the RECORD [º] button again briefly to start
recording. Input signal is recorded starting up to 2
seconds before the button was pushed.
The RECORD [º] button indicator lights when recording.
3. Press the [ª] button to stop recording.
To pause recording, press the RECORD [º] button. To
resume recording to the same file, press the RECORD [º]
button again.
Press the [ª] button after pausing to complete the
creation of an audio file with the music recorded up to the
moment that recording was paused.
TIP
Use this function in combination with the auto-recording
function to record without missing the beginning of a
performance.
NOTE
If the unit was put into recording standby less than 2 seconds
before this function is used, recording will start from the time
when recording standby was enabled.
Recording the input sound with the
playback sound (overdubbing)
You can combine the input signal with the signal from an
already recorded le being played back to record a new le.
For example, you could record a new instrument part over an
existing track.
NOTE
When overdubbing, You cannot use the auto-record or
•
manual file incrementation functions.
You cannot pause during overdubbing. (The
•
RECORD [º]
button does not respond if pushed.)
5–Recording