Filter
Top Products
82
TASCAM HS-20
10 – Internal settings
NOTE
•
A mark appears on the button of the currently active
master clock.
•
If synchronization from an external clock is interrupted,
the unit’s internal clock becomes active. In this case, the
mark appears on the INT button to show that it has become
the active clock, and the mark appears on the button of
the selected external clock that was lost.
SYNC page
Make settings related to synchronization on this page.
NOTE
If an optional SY-2 has not been installed, the items will be
shaded and cannot be set.
STATUS
Shows the current sampling frequency and clock synchroni-
zation status.
TC Chase
Use to turn playback synchronized with timecode ON or OFF
(default).
Set it to ON when you want to match the timing of this unit’s
audio with a timecode master device (audio recorder, video
or built-in timecode generator).
You can also set the timecode offset (TC Offset) to be used
with the timecode master device. Touch the EDIT button to
open the CHASE Offset screen where you can set the offset
value in a range between −23:59:59.29 and +23:59:59.29.
(Default: 00:00:00.00)
NOTE
TC Chase can also be turned ON and OFF by pressing the
SHIFT and CALL keys at the same time.
TC Rechase
When ON, this function re-synchronizes when synchroni-
zation with timecode becomes inaccurate during playback.
(Default: OFF)
When set to OFF, after synchronizing once, input timecode is
ignored and the unit operates in free run mode.
When set to ON, set the amount of inaccuracy that triggers
rechasing. To set the time, touch the knob, and adjust the
value using the DATA dial.
Select a value in frames of 1/3, 1, 2 (default), 5 or 10.
Master TC
Set whether the unit synchronizes with the built-in timecode
generator or with timecode input from another device.
Internal button: Synchronize with the built-in generator.
External button (default): Synchronize with timecode input
from another device.
T/C page
Make settings related to timecode on this page.
Set to free run
Set to jam sync (and free once)
NOTE
If an optional SY-2 has not been installed, the items will be
shaded and cannot be set.
STATUS
This shows the timecode generator mode of the unit and the
current timecode frame type.
GENERATOR
The top line shows the current timecode generator time.
The bottom line shows the user bits (UB).