Filter
Top Products
76
TASCAM HS-20
9 – Playlist mode
Playback in playlist mode
Selecting a playlist
1. Press the FILE LIST key on the front of the unit to open the
playlist selection screen.
2. Touch the name of the playlist that you want to play to
select it. Its background becomes yellow.
3. Touch the MENU button on the Playlist selection screen to
open a pull-up menu.
Playlist selection screen pull-up
4. Touch the LOAD button in the pull-up menu to load the
playlist. A confirmation pop-up window will appear.
Touch the OK button or press the DATA dial. When loading
completes, the Home Screen opens.
NOTE
On the playlist selection screen, instead of touching the
MENU button followed by the LOAD button in the pull-up
menu, you can also touch the e button for the playlist that
you want to play to load it.
The same pop-up message as above appears. Touch the OK
button or press the DATA dial.
Playback control in playlist mode
Press the PLAY key to start playback.
Press the PAUSE key to start playback standby.
Press the PLAY key again to resume playback.
Press the STOP key to stop playback.
Press the . [MARK.] key or / [MARK/] key to
switch entries.
Press and hold the m [ ] key or , [ ] key to search
backward or forward.
Press the . [MARK.] or / [MARK/] key while
pressing and holding the SHIFT key to move between marks.
Press and hold the m [ ] key or , [ ] key while
pressing and holding the SHIFT key to search at high-speed.
NOTE
•
On the PLAY SETUP screen, you can set whether only the
currently selected entry is played or whether all the entries
within the current playlist are played. You can also enable
and disable repeat playback. (See “Playback settings (PLAY
SETUP)” on page 80.)
•
Playback can also be controlled through the PARALLEL port.
Using the call function in playlist mode
Press the CALL [CHASE] key to locate to the point where
playback was last started from playback standby (call point) and
put the unit in playback standby mode.
Using the flash start function in playlist
mode
Using a TASCAM RC-HS20PD (sold separately) or other remote
controller, flash start playback is possible.
For details, see “Flash start function” on page 109.