Filter
Top Products
18
TASCAM HS-20
2 – Names and functions of parts
o Folder Name mode button
Use the folder name as the first half of the take name.
o Date/Time mode button
Use the date/time for the first half of the take name. (The
format is “yyyymmdd-hhmmss”.)
Example: If it was created at 3:10:20 PM on July 1,
2014, the first half of the take name will be
“20140701-151020”.
o Second half of take names
The second half of the take name is comprised of one
alphabetical letter and a three-digit number. Touch the
EDIT button to open the screen where you can change
the letter.
You can change the three-digit number with the +
and – buttons. You can also touch the numerical part to
highlight it in yellow and use the DATA dial to change
the number.
In the following cases, “---” appears and the value cannot
be changed.
o The current folder is not loaded.
o The selected card is unavailable
o When the numerical part of the file name of the
current take is 999
CAUTION
•
The Next Take Name setting is saved to the SC/CF card. If
you change cards, the setting on that card will be used.
(Even when using a card created on another HS series unit,
the setting will change when you change the folder.)
•
The numerical part of the second half of the take name can
be changed even during playback and recording.
(The first half of the take name and the letter in the second
half can only be changed when stopped.)
NOTE
If the first half of the take name or the letter in the second
half is different, a take that has the same three-digit number
in the second half can be created.
s INFO button
Touch this button to open an information display that shows
the file name of the region at the timeline cursor and the
current unit settings beneath the track display area.
The upper section shows the file name of the region at the
timeline cursor.
The lower section shows the current sampling frequency,
recording bit length and frame type settings.
d Mark List button
Touch this button to open the mark list. (See “Mark list
screen” on page 105.)
f Manual Locate button
Touch this button to open the MANUAL LOCATE screen. (See
“Manual locate function” on page 108.)
In take and playlist modes
k
m
hj
l
;
z
x
c
v
bn
g
In take mode
NOTE
When in playlist mode, the INPUT MONITOR, EDIT and NEXT
TAKE NAME buttons are not shown.
g Timer event function status button
This shows timer event function status. (Take mode only)
: Timer event function on
: Timer event function off
: Timer event has been edited, but not saved