Filter
Top Products
TASCAM HS-20
63
8 – Take mode
Combining takes
You can combine a specified take with another one.
NOTE
You cannot combine takes in the following cases.
•
The bit lengths, the numbers of channels or the
sampling frequencies are different.
•
The file size after combining the takes exceeds the Max
File Size shown on the REC SETUP/FILE FORMAT screens.
•
The open capacity of the media is less than the file size
of the second take to be combined.
1. Press the HOME key on the front of the unit to open the
Home screen.
2. Set the take that will be the first half of the combined take as
the current take.
3. Touch the EDIT button to open the pull-up menu.
Touch the Combine button on the pull-up menu.
4. When the take selection screen opens, touch the e button
of the take to be combined with the current take.
(The yellow icon indicates the first take to be used in the
combination, which was as selected in step 3.)
5. A confirmation message appears, and an interval of
4-seconds in total before and after the take combination
point will be played repeatedly.
Touch the OK button or press the ENTER key to combine the
takes.
Touch the CANCEL button or press the EXIT/CANCEL key
to stop the repeat playback and reopen the take selection
screen.
6. While combining, a progress bar is shown in the pop-up
window.
When combining is complete, the pop-up window will
disappear.
NOTE
•
The file name of the first take is used for the combined take.
•
The timecode information from the first take is used in the
combined take.
•
If the combined number of mark points of the takes exceeds
100, the 101st and subsequent ones will be lost. These mark
points cannot be recovered with UNDO.
CAUTION
It is possible to combine takes that are already in use in
timeline or playlist mode.
If you combine such takes, an error pop-up appears when
you attempt to play the corresponding region/entry.