Filter
Top Products
47
Tape – Play/Recording
Tips
• When you record on both sides, be sure to start
from the top side. If you start from the bottom side,
recording stops at the end of the bottom side.
• If you select both sides recording and the tape
reaches the end of the top side part-way through a
track, the entire track is recorded again from the
beginning of the bottom side.
• You can record only your favourite CD tracks with
Programme Play. After step 2, follow the same
procedures as from step 1 to 5 of “Programming CD
tracks” on page 11, then go to step 3.
Note
If the tape becomes full during recording, the CD
player and the tape deck stop automatically.
Recording a CD on an MD and
a tape at the same time
1 Load a recordable MD and tape.
2 Load a CD you want to record.
3 Press SYNCHRO MODE repeatedly until
“DUAL SYNC” appears.
4 Follow the same procedures as from
step 4 to 6 of “Recording a CD on a
tape” on page 46.
To stop recording
Press x.
Tip
Even if the MD or the tape ends part-way through the
recording, the other continues recording.
Recording an MD on a
tape
— MD-TAPE Synchro Recording
You can use TYPE I (normal) tape.
1 Load a recordable tape.
2 Load an MD you want to record.
3 Press SYNCHRO MODE repeatedly until
“MD-TAPE SYNC” appears.
4 Press ENTER/START.
“Press START” flashes.
The tape deck stands by for recording and
the MD deck pauses for play.
Press TAPE nN again to record on the
bottom side.
5 Press PLAY MODE/DIRECTION
repeatedly until g appears to record
on one side or h (or j) to record on
both sides.
6 Press ENTER/START while “Press
START” flashes.
Recording starts.
When the recording is completed, the tape
deck and the MD deck stop automatically.
To stop recording
Press x.
continued