Filter
Top Products
11
CD
Programming CD tracks
— Programme Play
You can make a programme of up to 25 tracks.
1 Press FUNCTION repeatedly to switch
the function to CD.
2 Press PLAY MODE/DIRECTION (or
PLAY MODE on the remote) in stop
mode repeatedly until “PGM” appears.
3 Press l or L (or . or > on
the remote) repeatedly until the desired
track number appears.
Selected
track number
Playing time of
the selected track
4 Press ENTER/YES on the remote.
The track is programmed.
“Step” appears, followed by the number of
the track in the programmed sequence. The
last programmed track number appears,
followed by the total playing time of the
programme.
If you made a mistake, you can clear the last
programmed track from the programme by
pressing CLEAR on the remote.
Last programmed
track number
Total
playing time
5 To programme additional tracks, repeat
steps 3 and 4.
6 Press CD NX.
Other operations
To Do this
Check the
programme order
Press l or L (or . or
> on the remote) repeatedly
during Programme Play.
Check the total
number of
programmed
tracks
Press DISPLAY on the remote in
stop mode. The total number of
programmed steps appears,
followed by the last programmed
track number and the total playing
time of the programme.
Cancel
Programme Play
Press PLAY MODE/DIRECTION
(or PLAY MODE on the remote)
in stop mode repeatedly until both
“PGM” and “SHUF” disappear.
Add a track to
the end of the
programme in
stop mode
Perform steps 3 and 4.
Erase a track Press CLEAR on the remote in
stop mode. Each time you press
the button, the last programmed
track is erased.
Select the desired
track using the
number buttons
on the remote
Press number buttons instead of
performing step 3 through 5. To
use number buttons, see page 10.
continued