Filter
Top Products
43
Tuner
Tuner
Presetting radio stations
You can preset 20 stations for FM and
10 stations for AM.
1 Press ?/1 to turn on the system.
2 Press TUNER BAND repeatedly to
select “FM” or “AM”.
3 Press TUNING MODE repeatedly until
“AUTO” appears.
4 Press m or M.
The frequency indication changes and the
scanning stops when the system tunes in a
station. “TUNED” and “STEREO” (for a
stereo programme) appear.
5 Press MENU/NO on the remote.
6 Press l or L (or . or > on
the remote) repeatedly until “Memory?”
appears, then press ENTER/YES on the
remote.
A preset number appears. The stations are
stored from preset number 1.
Preset number
7 Press ENTER/YES on the remote.
“Complete!” appears.
8 Repeat step 2 through 7 to store other
stations.
To stop scanning
Press TUNING MODE.
To tune in a station with a weak
signal
Press TUNING MODE repeatedly until both
“AUTO” and “PRESET” disappear in step 3,
then press m or M repeatedly to tune in the
desired station.
To change the preset number
Start over from step 2.
To change the AM tuning interval
(except for the European model)
The AM tuning interval is factory-set to 9 kHz
(10 kHz in some areas). To change the AM
tuning interval, tune in any AM station first,
then turn off the system. While holding L,
turn the system back on. When you change the
interval, all the AM preset stations are erased.
To reset the interval, repeat the same
procedure.
Note
You cannot change the AM tuning interval in the
Power saving mode.
Tip
The preset stations are retained for about a day even if
you disconnect the mains lead or if a power failure
occurs.