Filter
Top Products
27
MD – Recording
Note
You cannot mark track numbers automatically if the
sound source to be recorded is noisy (e.g., tapes or
radio programmes).
1 Press FUNCTION repeatedly to switch the
function to MD.
2 Press MENU/NO on the remote.
3 Press l or L (or . or > on the
remote) repeatedly until “Setup?” appears,
then press ENTER/YES on the remote.
4 Press l or L (or . or > on the
remote) repeatedly until “T.Mark Off” or
“T.Mark LSync” appears, then press
ENTER/YES on the remote.
5 Press l or L (or . or > on the
remote) repeatedly to select the setting,
then press ENTER/YES on the remote.
To Select
Notes
• The recorded “LP:” is a stamp which appears to
indicate that the track cannot be played back when
you try to play the track on system that does not
support MDLP mode. It does not appear for systems
that support MDLP mode.
• When set to “On”, “LP:” is recorded as the track
title, so the number of characters that can be input
to an MD is reduced. In addition, if you divide an
“LP:” track using the Divide Function, “LP:” is also
added to the latter track.
Marking track numbers
• Automatically during recording
Track numbers are automatically marked as on
the original source during recording from this
system’s CD player or components connected
to DIGITAL OPTICAL IN jack. Use the Level
Synchro Recording Function to automatically
mark track numbers during recording from this
system’s tuner or components connected to the
ANALOG IN jacks.
• At any point during recording
You can mark track numbers during recording
of any source.
• After recording
Use the Divide Function (see “Dividing
recorded tracks” on page 38).
Marking track numbers
automatically during recording
— Level-Synchro Recording
The Level Synchro Recording Function is
factory set to on, so the track numbers are
automatically marked. If “L-SYNC” does not
appear during recording, turn on the Level
Synchro Recording as follows. Track numbers
are automatically marked when the input signal
is continuously below a certain level for more
than two seconds and then exceeds that level.
Turn on the Level
Synchro Recording
Function
T.Mark LSync
(factory setting)
Turn off the Level
Synchro Recording
Function
T.Mark Off
When you set the Level Synchro Recording
Function, “L-SYNC” lights up.
6 Press MENU/NO on the remote.
To continue and record, follow the
procedures described on the various
recording pages.
continued