Filter
Top Products
28
To change the trigger level for Level
Synchro Recording
Perform the following procedure to change the
signal level that triggers Level Synchro
Recording.
1 Press MENU/NO on the remote during
recording pause to display “Setup?”, then
press ENTER/YES on the remote.
2 Press l or L (or . or > on the
remote) repeatedly until “LS(T)” appears,
then press ENTER/YES on the remote.
3 Press l or L (or . or > on the
remote) repeatedly to select the level, then
press ENTER/YES on the remote.
You can set the level at any value between
–72 dB and 0 dB, in 2 dB steps. The factory
setting is –50 dB.
4 Press MENU/NO on the remote.
Marking track numbers at a specific
point during recording
— Track Mark
You can mark track numbers at any time during
manual recording, regardless of the type of
sound source.
Press z MD (or MD z on the remote)
during manual recording at the point you
want to add a track mark.
The tracks following the added one are
renumbered.
Note
The tracks might be recorded as the same single track
with a single track number when the same single
track of the same CD is recorded repeatedly.
Making a space between
tracks 3 seconds long
— Smart Space
Smart Space: Lets you make the blank
spaces between tracks 3 seconds long
automatically while making a digital recording
from a CD. For other types of recording, if the
Smart Space Function is on and there is no
sound input for about 3 seconds or more (but
less than 30 seconds) while recording, the MD
deck replaces this silence with a blank of about
3 seconds and continues recording.
No sound input for less than 30 seconds
Recording tips (continued)
Off
On
Replaced with a blank of 3 seconds and
recording continues
Auto Cut: When the Smart Space Function is
on, if there is no sound input for 30 seconds or
more, the MD deck replaces this silence with a
blank of about 3 seconds and enters recording
pause.
No sound input for 30 seconds or more
Off
On
Replaced with a blank of 3 seconds and
recording pauses