Filter
Top Products
20
Group Function: On
1 2 3 4 5 1 2 3 4
Recording tracks in
groups
— Group Function
What is the Group Function?
The Group Function allows you to play, record
and edit the tracks on an MD in groups. This is
convenient for managing multiple CD albums
recorded in MDLP mode onto a single MD.
The Group Function is turned on and off by
pressing GROUP.
Group Function: Off
1 2 3 4 5 6 7 8 9
Before you start recording
(continued)
Tab
Slide the tab
Operations using the Group Function
• Playing only the tracks in the desired group
(page 18)
• Labelling a group (page 32)
• Registering recorded tracks into a new group
(page 33)
• Releasing group registrations (page 34)
Note
MDs recorded using the Group Function of this
system can be used with other system that supports
the Group Function. However, note that the Group
Function operations of other system may differ from
the operations for this system.
Disc
Track
Disc
Group 1
Track
Group 2
Track
Note on MD track numbers
On an MD, the track numbers (track sequence),
track start and end point information, etc., are
recorded in the TOC*
3
area independent of the
sound information. You can edit recorded
tracks quickly by modifying the TOC
information.
*
3
TOC: Table Of Contents
After recording
Press Z MD to remove the MD or press
?/1 (power) to turn off the system.
“TOC” or “STANDBY” starts flashing. The
TOC is updated and recording is completed.
Before pulling out the mains lead
MD recording is completed when the MD
Table of Contents (TOC) is updated. The TOC
is updated when you eject the MD or press ?/1
to turn off the system. Do not pull out the
mains lead before updating the TOC or while
updating the TOC (while “TOC” or
“STANDBY” is flashing) to ensure a complete
recording.
Protecting a recorded MD
To protect a recorded MD, slide the tab on the
side of the MD to open the slot. In this position,
the MD cannot be recorded. To record on the
MD, slide the tab to close the slot.