Sony CMT-M100MD Stereo System User Manual


 
23
MD Recording
7 Press ENTER/START while Press
START flashes.
Recording starts.
When the recording of all selected tracks is
completed, the CD player and the MD deck
stop automatically.
To stop recording
Press x.
Tips
You can record only your favourite CD tracks with
Programme Play. After step 2, follow the same
procedures as from step 1 to 5 of “Programming CD
tracks” on page 11, then go to step 3.
Depending on the disc, CD TEXT information may
also be recorded (except when you record on an
MD and a tape at the same time). If “TEXT” flashes
during recording, see “Labelling an MD” on
page 30.
Note
If the MD becomes full during recording, the CD
player and the MD deck stop automatically.
Recording a CD on an MD and
a tape at the same time
1 Load a recordable MD and tape.
2 Load a CD you want to record.
3 Press SYNCHRO MODE repeatedly until
DUAL SYNC appears.
4 Follow the same procedures as from
step 4 to 6 of Recording a CD on a
tape on page 46.
Tip
Even if the MD or the tape ends part-way through the
recording, the other continues recording.
Recording a CD on an MD
with high speed
High-Speed CD-MD Synchro
Recording
You can make a digital recording of a CD on
an MD at twice the speed of normal CD-MD
Synchro Recording.
In step 4 of Recording a CD on an MD,
press SYNCHRO MODE repeatedly until
HISPEED SYNC appears.
In step 5, “×2” appears.
You cannot monitor the recorded signal during
high-speed recording.
If Retry flashes after you press
ENTER/START in step 5
A reading failure has occurred, and the system
is trying to read the data again.
If the retry was successful, the system
continues with High-Speed CD-MD Synchro
Recording.
If the condition of the loaded CD or the
system is poor, and retry fails, High-Speed
CD-MD Synchro Recording is disabled. In
this case, “×1” flashes and the MD deck
automatically starts recording in normal CD-
MD Synchro Recording. Note that
monitoring of the recorded signal is not
possible when this occurs.
continued