Filter
Top Products
Remote Control
39
9.7. Copy channel function
It is possible to copy a whole audio channel's settings to another channel or to multiple channels.
Note
Mono channels can only be copied to other mono channels, and stereo linked channels can
only be copied to other stereo linked channels.
1 On the Master unit's Comms page, press the soft key labelled Copy Mon (to copy mono
channels) or the soft key labelled Copy St (to copy stereo channels).
2 Use the touchstrip to select the channel that you wish to copy from. Note that only channels
of the selected type (mono or stereo) are shown.
3 Press the soft key labelled Confirm to select the source channel.
4 Now, the possible destination channels are shown. Use the touchstrip to select one or more
channels to copy to. Once all the destination channels are selected, press the soft key labelled
Confirm. The unit will display an “are you sure” message, and a final press of the Confirm soft
key will start the copying process.
At any time, the copy can be aborted by pressing the HOME button.
9.8. Solo Tracking operation
Instead of selecting slaves manually from the master unit, the Helix system can be controlled from
the solo system of Midas Heritage and Legend consoles. The console RS-232 port is connected to the
RS-232 connector (D9) on the rear of the master DN9340E unit using a straight-wired cable (no
crossovers). Once the channel assignments have been configured (see below), pressing a solo button
on the console will automatically select the channel of EQ that corresponds to that console function
onto the master unit, ready to be controlled.
To set up the assignment
1 First select the Comms page on the master unit.
2 Now press the second soft key (labelled “System”). This opens the system configuration
page.
• -A highlighted area shows the field that is currently being edited.
• -The left encoder scrolls up and down the list of units.
• -The touchstrip is used to select the column to be edited.
3 The following fields can be edited:
• Solo Tracking: This allows each audio channel to be associated with a type of solo
function on the Midas Heritage or Legend console. The available functions are: None,
Input, Group, Aux, Matrix, Solo Clear.
• Chan: This selects the particular channel solo that will be used for that channel of EQ.
So, for example, if slave EQ channel 1A is configured with Autosolo, set to Group and Chan to 5.
Then pressing group solo 5 on the console will select slave EQ channel 1A onto the master Helix unit
for control.
4 Once all the assignments have been made, press Confirm to return to the Comms page.