Filter
Top Products
Operation: DN9340E
13
6. OPERATION: DN9340E
6.1. Home Page
The home page is accessed from any of the EQ pages by pressing the HOME (SETUP) button. In the
setup menu the HOME (SETUP) button is pressed repeatedly to move through the menus. After the last
menu entry the display returns to the home page.
On the home page, the large display shows the overall system response. Along the top edge, on the
right, is the Memory number for the currently selected User or Preset Memory settings (storing and
recalling settings are described later).
The alphanumeric display shows the unit name and the name of the current working memory. On the
home page, the bypass button will bypass all processing for the selected channel (A, B or both if
linked for stereo in the setup menu).
6.1.1 Home page sub-menus
This menu provides controls for the overall delay of the system and the input gain trim.
The delay may be adjusted in coarse increments of 2.08ms (one sample at 48kHz sample rate) using
the left encoder or in fine increments of 0.02 ms with the centre encoder. It is displayed in time units
by default. Alternatively, the display can be selected to show distance in either Metric or Imperial
units. Details of changing the units are found in the Setup menu section on page 32.
The input gain control is adjusted by the right hand encoder between -40dB to +12dB in 0.1dB steps.
Below -40dB the gain is set to “Off” and this mutes the input signal.
Press HOME (SETUP) to return to home page.
6.1.2 A/B Link
This menu allows the unit to be linked for stereo operation.
Turn the right-hand encoder to select linked or non-linked (mono) mode. Note that when linking, the
currently displayed channel will be copied to the other channel, so that both channels are then
identical. In other words, if the “A” lamp (adjacent to SELECT button) is illuminated the settings for
Channel A will be copied to Channel B. If the “B” lamp is illuminated, the settings for Channel B will
be copied to Channel A.