Filter
Top Products
Setup Menu: DN9340E
34
7.11.2 Ethernet Subnet Mask Setup (Page 12)
After setting the IP Address, it is necessary to check the Ethernet IP Address Subnet mask on each
unit. The default subnet mask is 255.255.0.0.
To check and edit the Subnet Mask
1 Step through the Set Up menus to the
Ethernet S/Net Network setup page
shown opposite.
2 Turn the left control knob and the unit
will scan the Network to obtain the
Subnet Mask.
3 Turn the left control knob to highlight
the area of the Subnet Mask you wish
to change.
4 Now turn the centre control knob to
select a number from 0 to 255.
5 Press the HOME (SETUP) to confirm the
new Subnet Mask.
Note
It is important that all units and controlling PCs have the same Subnet
Mask to function correctly. You may want to modify Subnet Masks
where one area of the network is required to be ‘hidden’ from another,
for example, in an installation with one network but multiple
auditoriums. For more information on configuring your network, please
see the HELIX DN9340E and DN9344E RCS User Guide.
For more information on remote control setups, see Section 9.