Filter
Top Products
Using the DN9340E Memories
35
8. STORING AND RECALLING SETTINGS: DN9340E
The DN9340E includes two types of memory location, to provide maximum flexibility in a range of
applications. There are 32 user memories in battery-backed-up SRAM and 32 preset memories in
non-volatile FLASH memory. Recalling settings from either memory type uses the same procedure,
and the user memories can be stored directly from the front panel of the unit. However, the FLASH
memories can only be programmed directly from an external computer. This provides an absolute
safeguard for valuable system settings, particularly in fixed installations.
To store settings:
1 Press STORE.
2 Turn left encoder knob to select the destination (U01 to
U32), for example, “U02”.
3 Press STORE again to confirm (or HOME (SETUP) to abort). The
far left character of the store name flashes.
4 Use the centre encoder knob to select characters, and the
left one to move left and right, to enter a suitable name for
the memory. Alternatively, if the name already there
indicates that you do not want to overwrite it, then HOME
(SETUP) will abort the store operation as before.
5 Press STORE again to confirm. This will return you to the home page.
To recall settings:
1 Press RECALL.
2 Turn the left encoder to select the user (SRAM) memory
required, or the centre encoder to select a preset (FLASH)
memory, for example, “U02”.
3 Press RECALL again to confirm. The display will show the
following and then return you to the home page.