Filter
Top Products
Operation: DN9340E
17
6.2.2 Touchstrip operation with Graphic equalisation
On the Graphic EQ page, the touchstrip provides an alternative to using the encoder knobs for
selecting and operating the faders on the display. If you are not currently using the Freq/Level
menu, the unit automatically switches to it when you press the touchstrip. Touch either the upper or
lower part of the touchstrip below the fader frequency that you want to select. The fader will
highlight to indicate the selection. Tapping repeatedly at the same position will result in the fader
level moving up (upper strip) or down (lower strip) in 0.5dB increments. Pressing the strip
continuously in the same place will result in the fader ramping up or down over its full range. As an
aid to resetting faders to exactly 0dB, this ramping motion will stop as the fader passes over the 0dB
position. Release the touchstrip and then press again to continue moving past this point.
6.2.3 Grouping
Groups of faders can be created and moved together. This is achieved by pressing below one fader
on the upper strip, and below a different fader on the lower strip. A group will be created that
includes all faders between those two selected ones. This can now be moved up and down using the
encoder knob or by using the touchstrip in the area below the group. Pressing the touchstrip outside
the range of the group or moving the “frequency” encoder knob will disband the group.