Filter
Top Products
Operation: DN9340E
19
EQ remove page
This page allows the currently selected PEQ section to be deleted entirely (as opposed to
bypassed see IN/OUT below). The centre encoder is turned clockwise to remove the section,
and then the right encoder is also turned clockwise to confirm.
6.3.2 Touchstrip operation with Parametric equalisation
On the Parametric EQ page, the touchstrip can be used to select the currently active section of EQ as
an alternative to using the encoder knobs. If you are not currently using the Freq/Level menu, the
unit automatically switches to it when you press the touchstrip. Press either the upper or lower part
of the strip below the centre frequency of the required section. The centre frequency will highlight to
indicate the selection. Once selected, the frequency of the EQ section can be dragged up and down
the display by pressing the touchstrip and sliding the point of contact to left and right. There is no
difference between the upper and lower strips when in Parametric mode.