Filter
Top Products
79
21
INSTALLING THE VS-3 VOICE SYNTHESIZER UNIT
Always switch the power OFF and unplug the DC power cable first.
1 Remove the 6 screws from the lower cover of the
main unit.
2 Hold the VS-3 unit with the component side facing up,
then insert the VS-3 connector into the corresponding
transceiver connector.
• The component side must not face downward.
3 Replace the lower cover (6 screws).
INSTALLING THE PG-4X EXTENSION CABLE KIT
The PG-4X kit is available to extend the various
connection cables. For cable connections, see page 80.
With two PG-4X kits, you can extend the cables to the
maximum length.
The PG-4X kit also includes noise filters, modular plug
adapter cushions, and cable clamps. The following
diagrams illustrate how to install these accessories.
Component side
Approx. 3 cm
Approx. 3 cm
From front panel
From
microphone
Noise filter
INSTALLING OPTIONS
Modular plug
adapter
Cushion