Kenwood TM-V708A Stereo System User Manual


  Open as PDF
of 92
 
36
7
7 Repeat steps 5 and 6 to enter up to 8 digits.
8 Press [OK] to complete the setting.
9 Press [MNU] to exit Menu mode.
The keypad on the MC-58DM can also be used to enter
alphanumeric characters in step 5. Refer to page 18.
Note:
◆ You can also name the Program Scan {page 50} and DTMF
{page 58} channels, but you cannot name the Call channel
{page 37}.
◆ You can assign names only to memory channels in which you
have stored frequencies and related data.
◆ The stored names can be overwritten by repeating steps 1 to 9.
◆ The stored names also are erased by clearing memory channels.
NAMING A MEMORY CHANNEL
You can name memory channels using up to 8
alphanumeric characters. When you recall a named
memory channel, its name appears above the frequency.
Names can be call signs, repeater names, cities, names
of people, etc.
1 Recall your desired memory channel.
2 Press [MNU] to enter Menu mode.
3 Press [
cc
cc
c]/ [
dd
dd
d] to select “MEMORY (1–4–)”, then
press [OK].
4 Press [
cc
cc
c]/ [
dd
dd
d] to select “MEMORY NAME (1–4–4)”,
then press [OK].
• The display for entering a memory name appears and
the first digit blinks.
5 Turn the Tuning control to select the first digit.
•You can enter alphanumeric characters and special
ASCII characters.
6 Press [
aa
aa
a].
• The cursor moves to the next digit.
ciremunahplafostesehtgnomasehctiwS
.sretcarahcIICSAlaicepsdnasretcarahc
neewtebsehctiwS
latipacdnallams
.srettel
yromeMslecnaC
.yrtnEemaN
tatigidehtseteleD
.noitisoprosruceht
rosrucehtsevoM
.sdrawkcab
yltnerrucehtstresnI
.retcarahcdetceles
DNABtfel(
)LES
d
nastigidllasraelC
o
trosrucehtsnruter
.tigidtsrifeht
 previous next