Filter
Top Products
38
7
MEMORY-TO-VFO TRANSFER
You may sometimes want to search for other stations or
a clear frequency near the frequency stored in a memory
channel or the Call channel. In this case first transfer
the contents of a memory channel or the Call channel to
the VFO.
1 Recall your desired memory channel or the Call
channel.
2 Press [F], [M
ss
ss
sV].
• The entire contents of the memory channel or the Call
channel are copied to the VFO.
Note:
◆ A transmit frequency from an odd-split memory channel or odd-
split Call channel is not transferred to the VFO. To transfer a
transmit frequency, press [REV], then press [F], [M
ss
ss
sV].
◆ Lockout status and memory names are not copied from a memory
channel to the VFO.
◆ If you recall the Call channel in step 1, simply turning the Tuning
Control or pressing Mic [UP]/ [DWN] also transfers the contents to
the VFO. The frequency, however, is changed by one step.
CHANNEL DISPLAY
When in this mode, the transceiver displays only
memory channel numbers (and memory names if stored)
instead of frequencies.
1 Press [MNU] to enter Menu mode.
2 Press [
cc
cc
c]/ [
dd
dd
d] to select “MEMORY (1–4–)”, then
press [OK].
3 Press [
cc
cc
c]/ [
dd
dd
d] to select “CHANNEL DISPLAY
(1–4–2)”, then press [OK].
4 Press [
cc
cc
c]/ [
dd
dd
d] to switch this function ON (or OFF).
5 Press [OK] to complete the setting.
6 Press [MNU] to exit Menu mode.
Note: You cannot switch this function ON unless you can recall any
channel on both bands A and B.
When in Channel Display mode, you cannot use the
following functions:
tceleSdnab-buStceleSOFVnacSOFV
erotSyromeMerotSMPllaceRMP
OFV-ot-yromeM
refsnarT
teseRMP/lluF/laitraP
eziSpetSycneuqerF
egnahC
egnahCpetSzHM01/1kcoLlortnoc-llA