Filter
Top Products
59
12
■ Selecting TX Speed
Some repeaters may not respond correctly if a DTMF
number is transmitted at a fast speed. If this
happens, change the DTMF number transmission
speed from Fast (default) to Slow.
In Menu mode, access Menu 1–5–2 (TX SPEED) and
select “Slow”.
■ Selecting Pause Duration
You can also change the pause duration stored in the
memory channels. The default is 500 milliseconds.
In Menu mode, access Menu 1–5–3 (PAUSE) and
select from 100, 250, 500, 750, 1000, 1500, and
2000 ms.
■ Transmitting a Stored DTMF Number
1 Press Mic [PTT]+ Mic [PF].
2 Release Mic [PF] while still holding Mic [PTT], and
press Mic [UP]/ [DWN] to select the desired
DTMF memory channel.
3 While still holding Mic [PTT], press [0] to [9]
corresponding to the channel number.
• The number stored in the channel scrolls across the
display accompanied by DTMF tones from the
speaker.
• After transmission, the frequency display is restored.