Filter
Top Products
30
6
TRANSMITTING A 1750 Hz TONE
Most repeaters in Europe require a transceiver to
transmit a 1750 Hz tone. It is possible to program
[CALL] on the front panel as a key for transmitting a
1750 Hz tone.
1 Press [MNU] to enter Menu mode.
2 Press [
cc
cc
c]/ [
dd
dd
d] to select “REPEATER (1–7–)”, then
press [OK].
3 Press [
cc
cc
c]/ [
dd
dd
d] to select “1750 KEY (1–7–3)”, then
press [OK].
4 Press [
cc
cc
c]/ [
dd
dd
d] to select “1750”.
5 Press [OK] to complete the setting.
6 Press [MNU] to exit Menu mode.
• “1750” appears in place of “CALL”as the key label.
Note:
◆ You can also program a Mic PF key as the 1750 Hz Tone function
{page 60}.
◆ The transceiver continuously transmits a 1750 Hz tone until you
release Mic [CALL] or [CALL].
Some repeaters in Europe must receive continuous
signals for a certain period of time, following a 1750 Hz
tone. This transceiver is also capable of remaining in the
transmit mode for 2 seconds after transmitting a 1750 Hz
tone.
1 Press [MNU] to enter Menu mode.
2 Press [
cc
cc
c]/ [
dd
dd
d] to select “REPEATER (1–7–)”, then
press [OK].
3 Press [
cc
cc
c]/ [
dd
dd
d] to select “TX HOLD (1–7–4)”, then
press [OK].
4 Press [
cc
cc
c]/ [
dd
dd
d] to switch the function ON (or OFF).
5 Press [OK] to complete the setting.
6 Press [MNU] to exit Menu mode.
Note: While remaining in the transmit mode, the transceiver does not
continuously transmit a 1750 Hz tone.