Kenwood TM-V708A Stereo System User Manual


  Open as PDF
of 92
 
68
14
POWER-ON MESSAGE
Each time you switch the transceiver ON, “HELLO !!”
appears for approximately 2 seconds. You can program
your favorite message in place of the factory default.
1 Press [MNU] to enter Menu mode.
2 Select Menu 1–1–1 (POWER-ON MSG), then press
[OK].
• The display for entering a message appears and the first
digit blinks.
3 Turn the Tuning control to select a character.
•You can enter alphanumeric characters and special
ASCII characters.
4 Press [
aa
aa
a].
• The cursor moves to the next digit.
5 Repeat steps 3 and 4 to enter up to 8 digits.
6 Press [OK] to complete the setting.
7 Press [MNU] to exit Menu mode.
The keypad on the MC-58DM can also be used to enter
alphanumeric characters in step 3. Refer to page 18.
DISPLAY DEMONSTRATION
By initiating this function, various preprogrammed
displays appear. You still continue to use the transceiver
normally, in this mode. Pressing a front panel key or Mic
key, or turning the Tuning control restores the operating
display immediately. If there is no key entry or Tuning
control adjustment for approximately 10 seconds, the
transceiver reverts back to Demonstration mode.
Press [F]+ POWER ON to switch this function ON (or
OFF).
ciremunahplafostesehtgnomasehctiwS
.sretcarahcIICSAlaicepsdnasretcarahc
neewtebsehctiwS
latipacdnallams
.srettel
yromeMslecnaC
.yrtnEemaN
tatigidehtseteleD
.noitisoprosruceht
rosrucehtsevoM
.sdrawkcab
yltnerrucehtstresnI
.retcarahcdetceles
DNABtfel(
)LES
d
nastigidllasraelC
o
trosrucehtsnruter
.tigidtsrifeht
 previous next