Filter
Top Products
5
1
2 After the cable is in place, wind heat-resistant tape
around the fuse holder to protect it from moisture,
then tie down the full run of cable.
3 To prevent the risk of short circuits, disconnect
other wiring from the negative (–) battery terminal
before connecting the transceiver.
4 Confirm the correct polarity of the connections,
then attach the power cable to the battery
terminals; red connects to the positive (+) terminal
and black connects to the negative (–) terminal.
• Use the full length of the cable without cutting off
excess, even if the cable is longer than required. In
particular, never remove the fuse holders from the
cable.
5 Reconnect any wiring removed from the negative
terminal.
6 Connect the DC power cable to the transceiver’s
power supply connector.
• Press the connectors firmly together until the locking
tab clicks.
DC POWER CABLE CONNECTION
■ Mobile Operation
The vehicle battery must have a nominal rating of 12 V.
Never connect the transceiver to a 24 V battery. Be
sure to use a 12 V vehicle battery that has sufficient
current capacity. If the current to the transceiver is
insufficient, the display may darken during transmission,
or the transmit output power may drop excessively.
1 Route the supplied DC power cable directly to the
vehicle’s battery terminals using the shortest path
from the transceiver.
• When using a noise filter, install it with an insulator to
prevent it from touching metal on the vehicle.
•We recommend that you do not use the cigarette
lighter socket since some cigarette lighter sockets
introduce an unacceptable voltage drop.
• When routing the power cable through a hole in the
vehicle chassis or body, for example in the firewall at
the front of the passenger compartment, use a
rubber grommet to protect the cable from abrasion.
Dismantle the fuse holder to pass the cable through
the firewall.
• The entire length of the cable must be dressed to
isolate it from heat, moisture, and the engine
secondary (high voltage) ignition system/ cables.
Red
Black
Fuse holder
Fuse holder