Filter
Top Products
37
7
CALL CHANNEL
The Call channel can always be selected quickly no
matter what mode the transceiver is in. For instance,
you may use the Call channel as an emergency
channel within your group. In this case, the Call/VFO
scan {page 52} will be useful.
The default frequency stored in the Call channel is
144.000 MHz for the VHF band and 440.000 MHz for the
UHF band. The Call channel can be reprogrammed
either as a simplex & repeater or odd-split channel.
Note: Unlike channels 1 to 200 the Call channel cannot be cleared.
■ Recalling the Call Channel
1 Select your desired band.
2 Press [CALL] to recall the Call channel.
• “CALL” appears.
•To restore the previous mode, press [CALL] again.
■ Reprogramming the Call Channel
1 Select your desired band.
2 Press [VFO].
3 Select the desired frequency and related data
(Tone, CTCSS, etc.).
• When you program the Call channel as an odd-split
channel, select a receive frequency.
4 Press [F], [C.IN].
• The selected frequency and related data are stored
in the Call channel.
• The previous mode is restored.
• When programming as an odd-split channel, press
[F], [C.IN] (1 s) instead; “±” appears.
To also store a transmit frequency, proceed to the
next step:
5 Select the desired transmit frequency.
6 Press [C.IN].
• The transmit frequency is stored in the Call channel
and the previous mode is restored.
Note:
◆ Transmit Offset status and Reverse status are not stored in an
odd-split Call channel.
◆ To store data other than frequencies, select the data in step 3,
not step 5.