Filter
Top Products
35
7
CLEARING A MEMORY CHANNEL
Use the following procedure to clear an individual
memory channel. Full Reset {page 39} is a quick way to
clear all memory channels.
1 Recall your desired memory channel.
2 Switch the transceiver power OFF.
3 Press [MHz] (Tuning control)+ POWER ON.
•A confirmation message appears.
•To exit without clearing the memory channel, press
[ESC].
4 Press [OK].
Note:
◆ If you have recalled a memory channel on the non-control band
(A or B), you cannot select the same channel on the control band
to clear.
◆ When in Channel Display mode, you cannot clear any memory
channel.
RECALLING A MEMORY CHANNEL
1 Select band A or B.
2 Press [MR] to enter Memory Recall mode.
• The memory channel last used is recalled.
3 Turn the Tuning control, or press Mic [UP]/ [DWN], to
select your desired memory channel.
•You cannot recall an empty memory channel.
•To restore VFO mode, press [VFO].
When using a MC-58DM, you can also use its keypad to
recall a desired memory channel. First program one of
the Mic PF keys as the ENTER key {page 60}. In
Memory Recall mode press [ENTER], then enter the
channel number. To recall channel 3, for example, press
[ENTER], [0], [0], [3].
Note:
◆ When you recall an odd-split memory channel, “±” appears on the
display. Press [REV] to display the transmit frequency.
◆ After recalling a memory channel, you may program data such as
Tone or CTCSS. These settings, however, are cleared once you
select another channel or the VFO mode. To permanently store
the data, overwrite the channel contents {page 34}.