Filter
Top Products
49
9
■ Locking Out a Memory Channel
Select the memory channels you prefer not to monitor
while scanning.
1 Recall your desired memory channel.
2 Press [MNU] to enter Menu mode.
3 Press [
cc
cc
c]/ [
dd
dd
d] to select “MEMORY (1–4–)”, then
press [OK].
4 Press [
cc
cc
c]/ [
dd
dd
d] to select “LOCKOUT (1–4–3)”,
then press [OK].
5 Press [
cc
cc
c]/ [
dd
dd
d] to switch Lockout ON (or OFF).
6 Press [OK] to complete the setting.
7 Press [MNU] to exit Menu mode.
•A star appears beside a channel when it has been
locked out.
Note: The L0 to L9 and U0 to U9 memory channels cannot be
locked out.
GROUP SCAN
For Group Scan, the 200 memory channels are divided
into 10 groups, with each group containing 20 channels.
Group Scan monitors only the 20 channels which belong
to the specified group. The channels are grouped as
follows:
1 Recall one of the memory channels in your desired
group.
2 Press [MHz] (Tuning control) (1 s).
• Scan starts with the channel last recalled.
• The 1 MHz decimal blinks while scanning is in progress.
•To reverse the scan direction, turn the Tuning control
clockwise (upward scan) or counterclockwise
(downward scan). You can also press Mic [UP]/ [DWN].
3 To exit Group Scan, press [MHz] again.
Note:
◆ At least 2 memory channels in the specified group must contain
data and must not be locked out in order for Scan to function.
◆ You can also start Group Scan when in Channel Display mode.
While Scan is being interrupted, the channel number blinks.
02~1021~101
04~12041~121
06~14061~141
08~16081~161
001~18002~181