Filter
Top Products
73
16
3
Volume Change and Squelch Adjustment cannot both be
activated at the same time.
4
Volume Change and Squelch Adjustment must both be OFF
to change the tone or frequency step using this key.
You can also make the following settings by pressing [D]
first (ex. [D], then [2]).
1
After entering the selection mode, press [ ] or [#] to
change the level or selection.
Before pressing [D], [2], press [2] to activate the Tone,
CTCSS, or DCS function.
Press [OK] on the front panel of the transceiver to complete
the setting.
Note: Audible DTMF tones from other transceivers near you may be
picked up by your MC-58DM microphone. If so, this could prevent the
microphone control from working correctly.
2
/ycneuqerFSSCTCroenoT
tceleSedoCSCD
1
7tceleSB/AdnaB
8tceleSdnab-buS
3tceleSnoitceriDtesffO D
lecnaCedoMnoitcnuf-itluM
5kcoLdapyeKFMTD nwoD
6kcolnUdapyeKFMTD #pU
1nacSlausiV 9tnemtsujdAhcleuqS
3,2
2SCD/SSCTC/enoT 0egnahCrewoPXT
3esreveR AretnE
4egnahCpetSzHM1 BtceleSdnaBlortnoC
5rotinoM CretaepeR
6
tuodaeRycneuqerF
speeByb
1
D ]F[ yek
7egnahCemuloV
3,2
nwoD
4
8etuMrekaepS
#
pU
4
MICROPHONE CONTROL (WITH MC-58DM ONLY)
1
The transceiver announces the displayed information if you
have installed an optional VS-3 unit and selected “English” in
Menu 1–2–4 (VOICE) {page 77}.
2
After entering the selection mode, press [ ] or [#] to
change the level or selection.
You can change numerous transceiver settings by
operating the Mic DTMF keys.
To activate this function, access Menu 1–8–5 (MIC
CONTROL) and select “ON”.
The following table shows which functions are switched
ON/OFF or which settings are changed, by pressing the
DTMF keys.