Filter
Top Products
67
14
ADVANCED INTERCEPT POINT (AIP)
The VHF band is often crowded in urban areas. AIP
helps eliminate interference and reduce audio distortion
caused by intermodulation. You can use this function
when operating on the VHF band. Access Menu 1–3–5
(VHF AIP) and select “ON”.
Note:
◆ This transceiver does not allow you to use the AIP on the UHF
band.
◆ Switching the AIP ON also affects the VHF sub-band on band B.
Intermodulation and Sensitivity Adjustments
This feature will help reduce RF interference due to high
intermodulation in your area. If you experience
intermodulation interference, turn the AIP feature ON.
The TM-V708A design has good sensitivity performance
capability. If you do not experience interference in your
area, it is suggested to turn OFF the AIP for better signal
reception.
TIME-OUT TIMER (TOT)
It is sometimes necessary or desirable to restrict a single
transmission to a time limit. You may use this function to
prevent repeater time-outs when accessing repeaters, or
to conserve battery power.
When timer expires, warning tones sound and the
transceiver returns to reception mode. To resume
transmitting, release and then press Mic [PTT] again.
Access Menu 1–9–4 (TOT) and select 3, 5, or
10 (default) minutes.
AUTOMATIC POWER OFF (APO)
Automatic Power Off is a background function that
monitors whether or not any keys have been pressed or
the Tuning control has been turned. After 3 hours pass
with no operations, APO turns the power OFF. However,
1 minute before the power turns OFF, “APO” appears
and blinks, and a series of warning tones sound.
Access Menu 1–9–3 (APO) and select “ON”.
Note: If any settings are changed during the 3 hour period while APO
is ON, the timer resets. When you stop changing the settings, the
timer begins counting again from 0.