Filter
Top Products
61
14
If you press Mic [VFO] while entering a frequency, the
new data is accepted for the entered digits and the
previous data remains unchanged for the digits that are
not yet entered.
Note: The 1 kHz and subsequent digits may be corrected depending
on combinations of the previous frequency and the current frequency
step size.
If you press Mic [ENTER] while entering a frequency, the
new data is accepted for the entered digits and 0 is
programmed for the digits that are not yet entered.
AUXILIARY FUNCTIONS
Previous freq.:
145.350 MHz
Previous freq.:
145.350 MHz
DIRECT FREQUENCY ENTRY (WITH MC-58DM ONLY)
If the desired operating frequency is far from the current
frequency, using the Mic keypad is the quickest way to
change the frequency. First program one of the Mic PF
keys as the ENTER key {page 60}.
1 Press the left or right [BAND SEL] to select band A
or B.
• If necessary, press [F], then the same [BAND SEL] to
recall the sub-band.
2 Press [VFO].
3 Press Mic [ENTER].
• The display for Direct Frequency Entry appears.
4 Press the numeric keys in sequence on the keypad.
Note:
◆ The 1 kHz and subsequent digits are corrected according to which
key is pressed for the 1 kHz digit.
◆ Entering a digit that is outside the allowable range causes the
nearest digit within range to be displayed.
◆ You cannot enter a frequency in a band which cannot be recalled
on the current band.