Filter
Top Products
External Control
82 Runco X-200i Series Installation/Operation Manual
PRE
L
IMINAR
Y
Key Commands: The syntax for key commands is simple:
ky <keyname>[CR]
Some key command examples:
ky menu[CR] Bring up or cancel menu display.
ky cur.up[CR] Up arrow.
The response from the projector for key commands is ACK: followed by the same
command in UPPERCASE.
Input: ky menu[CR]
Response: ACK:MENU [CR]
Table 6-1 lists the serial command key names and IR codes.
Table 6-1. Serial Command Key Names and IR Codes
RS232
Keyname
Remote
Button
IR Code
Description
Set 1 Set 2
0x01 0xB7 Turn power on.
(none) 0x02 0xB8 Switch to the next source.
0x09 0xB9 Turn power off.
menu
0x15 0xBA Bring up or cancel menu display.
enter
0x17 0xBB Keypad enter.
cur.down
0x18 0xBC Keypad down arrow.
cur.up
0x1A 0xBD Keypad up arrow.
cur.left
0x1D 0xBE Keypad left arrow.
cur.righ
0x1F 0xBF Keypad right arrow.
0x80 0xC0 Bring up or cancel brightness slider.
0x81 0xC1 Bring up or cancel contrast slider.
(none) 0x84 0xC4 Force reacquisition of active source.
(none) 0x85 0xC5 Switch to the next gamma.
(none) 0x86 0xC6 Switch to 2.5 gamma.