Filter
Top Products
Installation
Runco X-200i Series Installation/Operation Manual 45
PRE
L
IMINAR
Y
Whitney (Prismatic)
Anamorphic Lens
Installation and
Adjustment
The Whitney Anamorphic lens mount kit consists of everything shown in Figure 3-20.
Some components shipped with your projector may differ slightly from what is shown in
these instructions.
Figure 3-20. Prismatic Anamorphic Lens Mounting Assembly - Exploded View
1. Use the Height/Pitch Adjustment Screws (3) and Washers (2) to attach the Lens
Mounting Bracket (5) to the Anamorphic Lens (1).
2. Remove the nut and rubber collar from each Swell Latch Assembly (4).
3. Secure the lens (with the mounting bracket attached) to the Lens Base Plate (6) using
the swell latches.
To avoid clipping the corners of the image, position the anamorphic
lens as close as possible to the primary lens.
3 Height/Pitch
Adjustment
Screw,
4-40 x 1/4"
(4x)
4 Swell
Latch
Assembly
(2x)
1 Anamorphic Lens
2 Washer (4x)
6 Anamorphic Lens
Base Plate
5 Anamorphic Lens
Mounting Bracket
Tip