Filter
Top Products
Operation
Runco X-200i Series Installation/Operation Manual 69
PRE
L
IMINAR
Y
Blank Screen: Select Blank Screen from the System menu to choose the color of the
blank screen that appears when no source signal is present. The options are Black, Blue
and White. The default is Black.
Auto Power Off: Set Auto Power Off to On to have the X-200i turn itself off after 20
minutes of inactivity (no source signal present).
Auto Power On: Setting Auto Power On to On causes the projector to automatically
power up when AC power is present. If the projector is plugged into a switched AC outlet,
this allows the projector to be turned on using a wall switch instead of the remote control
unit. If you do not need this capability, set
Auto Power On to Off (this is the default
setting).
Projection Mode: This control reverses all images and menus, and is necessary when
the projector is used in rear-projection applications. This control also flips the image so the
projector can be used in ceiling-mounted installations.
The default is Front Tabletop, for installations where the projector is upright and in fron of
the screen.
Logo Display: This controls whether or not the Runco logo appears during startup.
Altitude: Select Altitude from the System Menu to control the operation of the projector’s
cooling fan.
In most cases, the default setting (Auto) will maintain the correct operating temperature. If
the lamp frequently turns off due to overheating, or in certain high-altitude operating
environments, you may need to change this setting to High.
Power On Chime: This controls the audible chime at startup.
Frame Locking: This controls whether or not frame-locking is turned on for 2D sources.
(3D sources are always frame-locked.)