Filter
Top Products
External Control
Runco X-200i Series Installation/Operation Manual 93
PRE
L
IMINAR
Y
6.3
Using HDMI CEC
Messages
The X-200i accepts and can respond to CEC command messages from a disc player,
satellite receiver or DVR/set-top box via an HDMI connection. Using CEC, the X-200i can
perform the following actions:
• Turn itself on and select the correct input when the source component initiates
playback of a disc or recorded program.
• Turn the source component on when you switch to its corresponding input on the
X-200i.
• Turn the source component off when the X-200i is turned off (unless the source
component is in playback mode).
• Change its OSD language when a similar change is made at the source.
To use CEC, connect your CEC-compatible sources to the HDMI inputs on the X-200i.
Set the
HDMI CEC option to On (refer to HDMI CEC on page 71). Additional steps may
be needed to enable CEC at the source. Refer to the documentation for your source
device for more information.
CEC Command ListTable 6-4 lists the CEC commands supported by the X-200i.
Table 6-4. CEC Commands Supported by the X-200i
Opcode Value Parameters
Directly
Addressed
Broadcast
Feature Abort 0x00 [Feature Opcode]
[Abort Reason]
Yes No
Image View On 0x04 None Yes No
Set Menu Language 0x32 [Language] No Yes
Standby 0x36 None Yes Yes
User Control Pressed 0x44 [UI Command] Yes No
User Control Released 0x45 None Yes No
Give OSD Name 0x46 None Yes No
Set OSD Name 0x47 [OSD Name] Yes No
Vendor Remote Button Up 0x5B [Vendor Specific RC
Code]
Yes Yes
Active Source 0x82 [Physical Address] No Yes
Give Physical Address 0x83 None Yes No
Report Physical Address 0x84 [Physical Address]
[Device Type]
No Yes
Request Active Source 0x85 None No Yes
Set Stream Path 0x86 [Physical Address] No Yes
Device Vendor ID 0x87 [Vendor ID] No Yes
Vendor Command 0x89 [Vendor Specific Data] Yes No