Filter
Top Products
Maintenance and Troubleshooting
Runco X-200i Series Installation/Operation Manual 77
PRE
L
IMINAR
Y
5.1
Lamp Replacement
The lamp should be replaced when it reaches the end of its life (typically between 1,500
and 3,000 hours), or sooner if a noticeable degradation in brightness occurs. Contact your
Runco dealer to obtain a replacement lamp.
1. Turn off the projector and unplug the power cord. Allow the projector to cool
down for approximately 60 minutes prior to removing the lamp assembly for
replacement.
2. Open the rear door of the projector
by grasping the handle and pulling it
downward.
3. Loosen the captive screw on the
lamp cover and pull the lamp cover
out.
4. Loosen the two screws on the lamp
module.
5. Pull the lamp module handle firmly to
remove the lamp module.
6. Perform Steps 5 through 2 (in reverse
order) to install the new lamp
module.
7. Turn on the power. The lamp timer
will reset automatically.
5. Maintenance and Troubleshooting