Lexicon MPX G2 Stereo Amplifier User Manual


 
Lexicon
7-8
MPX G2 User Guide
Mix 0-100% Dry/Wet ratio
Level Off, -89 to +6dB Amount of effect in the processed signal
Tune, Tune1, 2 0-100 Pitch shift
(Optimize) 10-60ms (M), (D) An option of Tune 1 — Adjusts the amount of delay in
10-40ms (S) the tuner
P Dly 0-70ms (M), (D) Amount of delay before the onset of the effect
0-25ms (S)
Detune effects are useful for
thickening up sounds by adding
delayed/pitch shifted versions of
the original source. They can be
particularly effective when used to
simulate double-tracking. They
are also great alternatives to cho-
rus effects as a detuner can add
the richness of a chorus effect
without the audible sweep caused
by the chorus rate. Detuners are
also traditionally used to turn a six-
string guitar into a twelve-string, or
an in-tune piano into a honky-tonk.
The MPX G2 detuners are opti-
mized to provide very fine amounts
of pitch shift.
Detune (M) is a single-channel
detuner that creates a pair of sig-
nals, pitch-shifted up and down
from the input. The pair is always
mixed together, and presented
equally to the outputs.
Detune (S) creates a pair of sig-
nals, pitch-shifted up and down
from the inputs. The left and right
channels are separate.
Detune (D) sums left and right
inputs to mono,then creates two
pairs of signals, pitch-shifted up
and down from the inputs by Tune1
and Tune 2. The first pair goes out
the left, the second pair out the
right.
Detune (M), Detune (S) and Detune (D)
Detune (M) Detune (S)
Detune (D)
Effect1 and Effect2
Effect descriptions for all of the effects contained in Effect1 and Effect2 are combined in
this section.
Effect1 and Effect2 contain identical effects, except for the first seven effects in Effect1.
These are Pitch effects: Detune (M), (S) and (D), Shift (M), (S) and (D) and Diatonic Hmy.
In these effects, Tune controls the amount of pitch shift. The Optimize parameter (an
option of Tune) allows balancing of any artifacts vs. the amount of delay through the
effect. Higher settings of Optimize are good for chords and low notes, lower settings
minimize the delay through the effect.
* = Interpolated; ( ) = Option of preceding parameter
As the detune effects use up relatively few processing resources, they can be combined with
reverb and many other effects. When creating effects that don’t require pitch shifting by large
intervals (semitones) the detuners are the most efficient choice.
29 190
Detune (M)
43 190
Detune (D)
34 190
Detune (S)