Filter
Top Products
LexiconMPX G2 User Guide
1-4
1. Turn the front panel Output control all the way down
2. Connect the Left and Right outputs to two input channels of your mixer or
power amp
OR
Connect a pair of stereo headphones to the rear panel Phones jack
3. Connect your guitar to the MPX G2 front panel Guitar input
4. Set the MPX G2 front panel Input knob to 2 o’clock.
5. Select your guitar’s most powerful pickup, turn the guitar volume control up
all the way and play your loudest.
6. Watch the Level and Clip LEDs above the MPX G2 Input/Output knob. If the
red Clip LED comes on more than just occasionally during your very loudest
playing, back off the Input knob a bit. (With some guitars, the red LED may
never come on — that’s OK.) Now that you’ve got the Input knob set for your
loudest playing, feel free to change the controls of your guitar to any settings
you like as you audition the MPX G2.
7. While playing, slowly turn up the front panel Output knob until you reach a
comfortable listening level. (You will hear a slight ticking as this knob is
adjusted — this is normal.)
Now you’re ready to start listening to the Stand Alone programs (150-250).
Stand Alone:
Direct connection to
headphones, mixer or
power amp
Use with
Programs 150-250
Front Panel
Rear Panel
Turn Output to a comfortable
listening level.
Turn Input to 2 o'clock.
to stereo headphones to Left and Right inputs of a
mixer or power amp
OR